Behringer Rev2496 Uživatelský manuál stáhnout pdf (Strana 11)

V-VERB PRO REV2496

COMBI

Par. 1

Par. 2

Par. 1

Par. 2

V-Verb Dec ay ER/Rev Dry FX Leve

Concert Predelay Decay Dry FX Leve

Cathedral Predelay Decay Dry FX Leve

Theater Predelay Decay Dry FX Leve

Gold Plate Predelay Decay Dry FX Leve

Ambience Predelay Decay Dry FX Leve

Gated Predelay Density Dry FX Leve

Reverse Predelay Rise Dry FX Leve

Delay Predelay Delay 1 Dry FX Leve

X-over Delay Delay 1 Delay 2 Dry FX Leve

Chorus/Flanger Speed Moddly Mix* Gain*

Phaser Speed Depth Mix* Gain*

Tremolo Speed Phase Mix* Gain*

Compressor Threshold Ratio Attack M-Gain

Recall Edit

*) The push function of the mic control mutes the Dry signal,

the push function of the gain control mutes the effect signal (FX LVL)

Tab. 3.3: Effect parameters in COMBI. mode

If you wish to adjust the effect selection of the combinations,

press ENGINE A and load the desired preset into this engine.

Then, press ENGINE B and select the desired preset for engine

B (in both cases, confirm your selection by pressing OK/TAP).

To adjust the routing of a combination, first press the EDIT key

and select a routing using the PRESET wheel (Parallel 1 - 6,

Serial 1 - 4). Confirm by pressing OK/TAP. Ten routing

configurations are at your disposal:

A = Analog inputs/outputs; D = Digital inputs/outputs

Fig. 3.6: Routing options for various combinations

+ The routing, the selected preset numbers as well

as the four most important parameters (see table

3.2) of each of the two engines can be stored in any

combination. The settings of these four parameter

values are not overwritten in the engine presets.

As usual, you can implement more complex edits

of individual effects in the EDIT level of the engines.

3. OPERATION

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

Žádné komentáře

Behringer Rev2496 Uživatelský manuál Strana 11